7. Slide the right sprocket to remove any slack in the paper; then
lock it in place by pushing the sprocket lock down.
8. Attach the front paper guide by sliding it along the printer’s
mounting slots as shown below. Then close the front paper
guide.
9. Slide the edge guides to the middle of the top paper guide.
Make sure that the printer cover and the paper guide cover
are closed.
Note:
Always close the printer cover before printing. The printer does not
print when the cover is open.
2-24
2-24a
2
R
Sun-G+ Rev.C
A5 size Chapter 2
97/11/17 pass 3
Printing on Continuous Paper 2-13
To Next Page
Loading...
Need help?
General
