Epson LX-810 User Guide

Options
l Several tines of space occur in the printout.
Skip-over-perforation may be set. Set DIP switch 2-3 to
off.
l Skip-over-perforation is set but does not work.
You may have changed the DIP switches with the power
on. To make new DIP switch settings effective, turn the
power off, then on again.
l Skip-over-perforation is set, but the skip has shifted from
the perforation, or the perforation does not fall in the center
of the skip.
The page length for one page of the continuous paper may
be set incorrectly. Set DIP switches 1-3 and l-4, or use
control codes ESC C or ESC C 0 to set the correct page
length.
The loading position of the paper may be too high or too
low. Use the microadjustment feature to reset the loading
position.
l When printing ends, the paper feeds abruptly, and as it
resumes printing, the paper feeds backward and comes off
the putt tractor sprockets.
You may have selected the short tear-off, which you cannot
use with the pull tractor. Be sure to set DIP switch 2-l on.
l When you press the LOAD/EJECT button to eject the paper,
the paper comes off the putt tractor sprockets.
When the paper release lever is in the continuous paper
position, the paper feeds backward to eject. When using the
pull tractor, press the FORM FEED button to feed the paper
forward.
Troubleshooting 6-13

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)