Epson LX-810 User Guide

Options
With the roll paper holder, paper does not feed properly.
l
When you press the LOAD/EJECT button, the platen does not
rotate and paper does not feed.
You may be trying to feed paper while the printer is on
line (ON LINE light is on). Press the ON LINE button once to
set the printer off line; then feed the paper. After feeding
the paper, press the ON LINE button again to set the printer
on line.
l
When you press the LOAD/EJECT button, the platen rotates
but paper does not feed.
You may have pulled the paper release lever forward to the
continuous paper position. Push the paper-release lever
back to the single-sheet position.
The position of the roll paper may be wrong. Position the
paper roll so that the paper feeds off of the bottom of the
roll.
l The paper feed is crooked or the paper jams.
The roll paper holder may be installed incorrectly. Check
that the holes in the base fit onto the two corresponding
pegs at the bottom of the printer.
The shaft with the paper roll may not be properly mounted
on the roll paper holder. Make sure the shaft fits securely
onto the roll paper holder.
The position of the roll paper may be wrong. The roll
should be oriented so that paper feeds from the bottom.
The paper may be caught on the edge guides. Make sure
that the paper guide is installed over the paper and that the
edge guides are positioned at the center of the paper’s
width.
6-14 Troubleshooting

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)