Functions 2. Part Names and Functions
86 RC700 Series Rev.3
(16) RC700DU: DU OUT Connector / RC700DU-A: OUT Connector
The connector for Drive Unit.
(17) Development PC connection USB port
This port connects the Controller and the Development PC using a USB cable. Do
not connect other devices except the Development PC.
For details, refer to 7. Development PC Connection USB Port.
(18) Memory port
This port connects the common USB memory for Controller backup function. Do not
connect other USB devices except the USB memory.
For details, refer to 8. Memory Port.
(19) Trigger Switch
This switch is for Controller backup function using the USB memory.
For details, refer to 8. Memory Port.
(20) LAN (Ethernet communication) port
This port connects the Controller and the Development PC using an Ethernet cable.
100BASE-TX / 10BASE-T communication is available.
For details, refer to 9. LAN (Ethernet communication) Port.
(21) I/O connector
This connector is used for input/output device. There are 24 inputs and 16 outputs.
For details, refer to Setup & Operation 13. I/O Connector.
(22) AC IN
The connector for 200VAC power input.
For details, refer to 3.3.2 AC Power Cable.
(23) Control Unit Signature label
The serial number of the Control Unit and other information are shown.
To Next Page
Loading...
