Functions 3. Installation
RC700 Series Rev.3 97
3.2.2 Installation
Install the Controller on a flat surface such as wall, floor, and Controller box in the
d
irection shown from (A) to (C).
(A) Flat Mounting
(Figure: RC700)
(B) Upright Mounting
* The rubber foot needs to be replaced.
Attach the rubber foot with the flat
side facing the controller.
The size of the screw that secure the
rubber foot is M4×8.
When replacing the rubber foot, be
careful not to lose the screw. Also, do
not use a screw of size other than
(C) Rack Mounting
* A plate for rack mounting is required.
F
or Controller installation to the Controller box or the base table, process screw holes as
follows.
- Ensure the air flow around the supply and exhaust ports, and install the Controller
while leaving space from other equipment or walls as below.
* Keep the space about 200 mm or more on the top to maintenance.
To Next Page
Loading...
