Rev. A Disassembly and Assembly 2-7
Confidential
TM-H6000/H6000P Service Manual
7. Hook the belt tension spring to the carriage motor and carriage sub assembly frame.
Figure 2-7
Pre-assembly of the Carriage Sub Assembly
1. Insert the oil-ring into the carriage head and lubricate. Insert the flat surface of the oil-ring
downward.
2. Hook the carriage spring to the carriage head. Push in until you feel the carriage spring
click.
3. Insert the carriage belt into the carriage sub assembly. Shape the belt along the groove on
the back side of the carriage sub assembly. The direction of the belt should be so that the
front side is facing the inside of the belt.
4. Pass the carriage guide gear into the carriage assembly and attach to the carriage sub
assembly with one E-ring. The groove in the carriage guide shaft E-ring should be toward
the right side. See the illustration on the next page.
5. Lubricate the left and right sides of the carriage guide shaft. See Appendix G for a
lubrication diagram.
6. Attach the carriage belt to the carriage transmission pulley and carriage drive pulley.
685
E-ring(2)
602
Belt drive cap
631
Carriage drive pulley
731
screw(C.P.S-tite(P4),3X6)
731 screw(C.P.S-tite(P4),3X6)
628 Belt tension spring
697
Carriage motor
To Next Page
Loading...
Need help?
General