Disassembly and Assembly 2-8 Rev. A
Confidential
7. Firmly tighten the carriage motor lead wire stopper screw.
8. Use one screw to attach the carriage to the carriage sub assembly.
Figure 2-8
9. Set the intermediate circuit board cover onto the intermediate circuit board.
10. Position and attach the intermediate circuit board to two nibs on the carriage frame
assembly. Fix with two screws. (see the illustration on the next page.)
604
Oil ring
604 Oil ring
677 Carriage assembly
610
Carriage spring
688 E-ring(5)
629 Carriage guide shaft
To Next Page
Loading...
