Rev. C FAQ C-9
TM-H6000III Technical Reference Guide
4. Turn off the printer and turn it on again.
5. Confirm that EPSON USB Controller for TM/BA/EU Printers is shown in Universal
Serial Bus controllers.
6. Open the port tab of the printer property; change the port USB001 to TMUSB000-Printer.
C.3.5 What should be considered for a DM connection?
❏ Fix the baud rate of a DM to 19200 bps.
❏ Turn on the power of a DM before turning on the power of the TM printer. Otherwise, the
DM is not recognized correctly.
❏ Use the DM connector on the USB interface board. When the USB interface is mounted on
the TM printer, the display module connector (DM connector) on the TM printer cannot be
used. Be sure to use the DM connector on the interface.
❏ Be sure to attach a ferrite core. To mount the ferrite core, put the display module cable into
the ferrite core.
C.3.6 Can a DM be connected?
❏ A DM can be connected to the DM connector on the USB interface board. The DM connector
on the TM printer cannot be used.
C.3.7 Is it possible to connect to devices that conform to USB 2.0?
❏ Yes, it is possible.
If the host controller of the PC conforms to USB 2.0, if a USB 2.0 hub is used, or a TM printer
is a HighSpeed model, the connection will be HighSpeed. Note the operating environment
for the HighSpeed connection described in “What are the usage conditions for a TM printer
with a USB interface?” on page 9 of this section.
C.3.8 What are the usage conditions for a TM printer with a USB interface?
❏ Operating systems
• FullSpeed (when the host controller is USB 1.1 and the TM printer is a FullSpeed model)
Windows 98SE
Windows 2000
Windows XP
To Next Page
Loading...
