1-26 General Information Rev. C
1.6.5 Installation
The printer must be installed horizontally.
1.6.6 Interfaces
❏ RS-232
❏ IEEE 1284 bidirectional parallel
❏ RS-485 (dealer option)
❏ USB (dealer option)
❏ 10BASE-T/100BASE-TX (dealer option)
Vibration resistance: When packed:
Frequency: 5 to 55 Hz
Acceleration: 2 G
Sweep: 10 minutes (half cycle)
Duration: 1 hour
Directions: x, y, and z
No external or internal damage should be found after the
vibration test, and the unit should operate normally.
Impact resistance: When packed:
Package: EPSON standard package
Height: 50 cm {19.69"}
Directions: 1 corner, 3 edges, and 6 surfaces
No external or internal damage should be found after the
drop test, and the unit should operate normally.
When unpacked:
Height: 5 cm {1.97"}
Directions: Lift one edge and release it (for all 4 edges).
When the printer is not printing, no external or internal
damage should be found after the drop test.
Acoustic noise (operating): Receipt:
When using autocutter:
Approximately 52 dB (bystander position)
To Next Page
Loading...
