3-4 Setup Rev. C
Note:
The default setting of the ESC/POS command is “Enable.”
3.1.4 Validation paper handling
1. Transmit the command from host PC to make the printer ready for a validation paper to
be inserted.
2. Insert a validation paper into the validation entrance from the upper side.
Note:
Use only validation paper (flat paper, without wrinkles, creases, or folds) that matches the
specifications.The validation function is a factory option.
Normal Mode
All covers are
closed
Paper roll cover
is opened
Unit cover is
opened
Front cover is
opened
If receipt is
selected
FEED Follow ESC/POS
command
Disabled Disabled Follow ESC/POS
command
RELEASE Follow ESC/POS
command
Enabled
If slip is
selected
FEED Follow ESC/POS
command
Follow ESC/POS
command
Enabled Enabled
RELEASE Follow ESC/POS
command
Enabled
Slip insertion
waiting status
Slip ejection waiting status
All covers are
closed
Paper roll cover
is opened
Unit cover is
opened
Front cover is
opened
If receipt is
selected
FEED— ————
RELEASE—————
If slip is
selected
FEED Disabled Follow ESC/POS
command
Follow ESC/POS
command
Enabled Enabled
RELEASE Disabled Follow ESC/POS
command
Enabled
insert the paper against the corner
incorrect insertion correct insertion
To Next Page
Loading...
