4-2 Maintenance & Troubleshooting Rev. C
4.1.2.2 Cleaning sheet
Use the following or an equivalent commercially available cleaning sheet:
PRESAT brand (KIC) “CHECK READER CLEANING CARD.”
4.1.2.3 Cleaning procedure
You can perform cleaning either in self mode or command mode. These modes are described
below.
4.1.2.4 Self mode
1. Load a paper roll in the printer.
2. Turn off the power.
3. Open the paper roll cover.
4. Turn the power back on while holding down the RELEASE button.
5. Press the RELEASE button seven times.
6. Close the paper roll cover.
7. The printer prints the following message on receipt paper and the SLIP light flashes.
8. Load the cleaning sheet like a standard check.
CAUTION:
Be sure that the sheet is inserted with the correct side up and that it is inserted in the
correct direction.
9. When the sheet is ejected, press the RELEASE button, and remove the sheet from the printer.
CAUTION:
Do not use a cleaning sheet more than once.
4.1.2.5 Command mode
1. Send the cleaning command to the printer.
2. Perform steps 8 and 9, as described in self mode.
To Next Page
Loading...
