Rev. C System Planning 2-13
TM-H6000III Technical Reference Guide
2.5 Ethernet
TM printers are connected to a network via a hub using an Ethernet cable.
Note:
If the TM printer is connected to the host PC via an Ethernet interface, a DM-D cannot be connected to
the TM printer.
We provide the IP address setup utility“EPSON TMNet WinConfig,” for setting the IP address of the
Ethernet model TM printer on the host PC. It is downloadable from the web site. See “Downloading
Drivers, Utilities, and Manuals” on page 2-8.
The Ethernet interface TM printer does not accept a customer display (DM-D). Connect the customer
display to a POS terminal or appropriate equipment other than the printer.
When controlling the printer with OPOS, it is necessary to use exclusive control. Therefore, when using 1
printer with several PCs, it is necessary to consider that application programming by a PC that already
has the exclusive right must release it; then another PC must claim it.
Names of parts
The names of the various parts of the Ethernet interface are shown below.
10BASE-T/100BASE-TX Ethernet
interface connector
LED (Green)
LED (Yellow)
Push button
To print the parameters for the interface,
press the button and hold it for more than 3 seconds.
To Next Page
Loading...
