3-20 Setup Rev. C
NOTE:
If the print density is set to level 3 or 4, printing speed is usually reduced.
For a tip about print density, see “When Using Original Paper” (page 3-20).
3.4.3.5 When Using Original Paper
When you use original paper such as P350 (F380), we recommend setting the DIP switches as
shown in the table below. The setting differs depending on each paper specification. See the
Other Qualified Suppliers for Thermal Paper section later in this chapter.
Note:
See the thermal paper section in Chapter 4 for information about thermal paper.
3.4.4 Memory Switches
This printer has “Memory switches“ which are software switches. A memory switch setting
utility can change the memory switch 1 or 8 to ON or OFF as shown in the table below (default:
all OFF):
• Switch 1
• Switch 8
Original paper type
DIP SW2
Print density
level34
P350 (F380) ON ON 1
PD160R, AF50KS-E, P310, P300 OFF OFF 2 (default)
Bit ON OFF
1 Transmits the power ON notice Does not transmit the power ON notice
2 ~8 Reserved (Do not change the setting)
Bit ON OFF
1-3 Reserved (Do not change the setting)
4 Uses two-color roll paper Uses monochrome roll paper
5 Reserved (Do not change the setting)
6 Error signal output: Disabled Error signal output: Enabled
7 Slip paper jam detection: Disabled Slip paper jam detection: Enabled
8 Becomes recoverable error if the unit cover and
front cover is open during printing
Goes offline if the unit cover and
front cover is open during printing
To Next Page
Loading...
