2-10 System Planning Rev. C
2.3 Serial Connection
When the TM printer is connected to the host PC with a serial interface, the following connection
forms are possible:
•Stand alone
• Y-connection
• Pass-through connection
Connections for usable serial cross cables are as follows:
The type of cable that should be used depends on the operation and the handshake method for
the TM printer. You can operate the TM printer by Windows driver, OPOS, JavaPOS, or ESC/
POS commands. XON/XOFF, DTR/DSR, or RTS/CTS are available as handshake controls. See
tables in following sections for the type of cable for each connection.
To Next Page
Loading...
