Epson TM-H6000III - Printing and Cutting Positions

Rev. C General Information 1-19
TM-H6000III Technical Reference Guide
1.4.4.5 Printing and Cutting Positions
Printing and cutting positions
NOTE: Numeric values used here are typical values; the values may vary slightly as a result of paper slack or
variations in the paper. Take this into account when setting the cutting position of the autocutter.
A
pprox. 27
A
pprox.13
Manual cutter position
A
utocutter head
p
osition
Center of the print dotline
Paper feed direction
[Units: mm (All the numerical values are typical.)]
Approx. 24
Approx. 10