1-14 General Information Rev. C
NOTE:
1. Do not install the printer near any magnetic fields, because this may cause MICR reading errors. (Be sure to
check the MICR recognition rate when the printer is used near a display device.)
2. MICR characters may not be recognized when impact or vibration is applied to the printer.
Endorsement printing
1.4.3.4 Notes on using the MICR reader (only when the printer is used with MICR)
❏ The personal checks must be flat, without curls, folds, or wrinkles (especially at the edges).
Otherwise, the check may rub against the ribbon and become ink-stained.
❏ Do not insert checks that have clips or staples. These may cause paper jams, MICR reading
errors, and damage to the MICR head.
❏ Let go of the check immediately as soon as the printer starts feeding it. Otherwise, the paper
is not fed straight, causing paper jams and MICR reading errors.
[Units: mm (All numeric values are typical.)
To Next Page
Loading...
