Epson TM-H6000III - Maintenance Area; Comparison Table

Rev. C General Information 1-29
TM-H6000III Technical Reference Guide
1.9 Maintenance Area
The illustrations below show the area around the printer required for maintenance.
NOTE:203 mm =8"
56 mm =2.2"
345 mm =13.6"
282 mm =11.1"
1.10 Comparison Table
Differences between the TM-H6000III and the previous model, the TM-H6000II, are shown in
the following table.
Specification related items TM-H6000II TM-H6000III
Thermal print speed(slip) Approximately 5.14lps Approximately 5.7lps
Thermal print speed(Receipt) max 170mm/s (at24V,
Print density level 2)
max 200mm/s (at24V,
Print density level 2)
Ladder barcode print speed max 114mm/s max 118mm/s
Paper feed speed Approximately 170 mm/s {6.7"/s}
continuous feeding
Approximately 200 mm/s {7.9"/s}
continuous feeding
Paper Roll Supply Device Section
Paper roll end detection
Detection method:
Reflective photo sensor
Detection method:
Micro switch
Printing and Cutting Positions Manual cutter position:
Approximately 27
Auto cutter position:
Approximately 10.5
Manual cutter position:
Approximately 24
Auto cutter position:
Approximately 10