Epson TM-H6000III

1-10 General Information Rev. C
1.4.2 Endorsement Section (Factory Option)
Note:
Character dot spacing can be changed by an ESC/POS command.
An endorsement printer cannot be installed on a printer with the validation function.
1.4.2.1 Paper Specifications
Cut sheet
Printing method: Shuttle impact dot matrix
Wire pitch approximately 0.353 mm {1/72"}
Head wire
configuration
8 print solenoids in a horizontal line
Characters per line: 40 columns
Print speed: Approximately 1.9 lps (lps: lines per second)
Number of characters: Alphanumeric characters: 95
International characters: 37
Extended graphics: 128
× 11 pages (including one space page)
Character structure 5 × 7 (total 240 dots horizontally)
Character size 1.1 × 2.42 mm (W × H)
Paper type: Normal paper
Paper size: 68-230 mm (W) × 68-297 mm (L)
{2.7 - 9.1"(W)
× 2.7 - 11.7"(L)}
Paper thickness: Single-ply (copy paper cannot be used) 0.09 mm - 0.2 mm
{0.0035 - 0.0079"}