Confidential
EPSON
TITLE
SHEET
REVISION
NO.
SHEETNEXT
135 134
TM-T88III series
Specification
(STANDARD)
B
Second byte (printer information)
Bit Off/On Hex Decimal Status for ASB
0 - - - Undefined.
1 - - - Undefined.
2 - - - Undefined.
3 Off 00 0 No autocutter error.
On 08 8 Autocutter error occurred.
4 Off 00 0 Not used. Fixed to Off.
5 Off 00 0 No unrecoverable error.
On 20 32 Unrecoverable error occurred.
6 Off 00 0 No automatically recoverable error.
On 40 64 Automatically recoverable error occurred.
7 Off 00 0 Not used. Fixed to Off.
Bit 3: If these errors occur due to paper jams or the like, it is possible to recover by correcting
the cause of the error and executing
DLE ENQ n (1 ≤ n ≤ 2). If an error due to a
circuit failure (e.g. wire break) occurs, it is impossible to recover.
Bit 6: When printing is stopped due to high print head temperature until the print head
temperature drops sufficiently or when the paper roll cover is open during printing, bit 6
is On.
Third byte (paper sensor information)
Bit Off/On Hex Decimal Status for ASB
0, 1 Off 00 0 Paper roll near-end sensor: paper adequate.
On 03 3 Paper roll near-end sensor: paper near end.
2, 3 Off 00 0 Paper roll end sensor: paper present.
On 0C 12 Paper roll end sensor: paper not present.
4 Off 00 0 Not used. Fixed to Off.
5, 6 - - - Undefined.
7 Off 00 0 Not used. Fixed to Off.
Fourth byte (paper sensor information)
Bit Off/On Hex Decimal Status for ASB
0-3 - - - Undefined.
4 Off 00 0 Not used. Fixed to Off.
5, 6 - - - Undefined.
7 Off 00 0 Not used. Fixed to Off.
[Default] n = 0 when DIP SW 2-1 is off, n = 2 when DIP SW 2-1 is on.
[Reference]
DLE EOT, GS r, Appendix G, Transmission Status Identification
To Next Page
Loading...
