Epson WF-C17590 Series User Manual

Code Problem Solution
132 Cannot print due to a lack of available memory. Try the methods below to reduce the size of the print
data.
❏ Change to a smaller paper size.
❏ Simplify the data by reducing the number of
images in the print data or reducing the number
of font types.
133 Cannot print on 2-sides due to a lack of available
memory. Only one side will be printed.
Try the methods below to reduce the size of the print
data.
❏ Change to a smaller paper size.
❏ Simplify the data by reducing the number of
images in the print data or reducing the number
of font types.
141 Error in the printer's HDD. The job has been canceled. Contact Epson support or an authorized Epson
service provider to replace the HDD.
151 Printing is not performed because the login user
name and the user name associated with the
condential job do not match.
Make sure you login with the same user name as the
user name associated with the
condential
job.
201 The memory is full.
❏ Print received faxes from Job Status in Job/
Status .
❏ Delete received faxes saved in the inbox from Job
Status in Job/Status.
❏ If you are sending a monochrome fax to a single
destination, you can send it by using Direct Send.
❏ Divide your originals in two or more to send them
in several batches.
202 The line was disconnected by the recipient machine. Wait for a while and then try again.
203 The product cannot detect the dial tone. ❏ Make sure that the phone cable is connected
correctly and the phone line is working.
❏ When the printer is connected to the PBX or the
terminal adapter, change the Line Type setting to
PBX.
❏ Tap Settings > General Settings > Fax Settings
> Basic Settings > Dial Tone Detection, and
then disable the dial tone setting.
204 The recipient machine is busy. Wait for a while and then try again.
205 The recipient machine does not answer. Wait for a while and then try again.
206 The phone cable is incorrectly connected to the LINE
and EXT. port of the product.
Check the connection of the LINE port and the EXT.
port of the printer.
207 The product is not connected to the phone line. Connect the phone cable to the phone line.
208 The fax could not be sent to some of the specied
recipients.
Print a Fax Log or Last Transmission report for
previous faxes from Fax Report in the Fax mode to
check the failed destination. When the Save Failure
Data setting is enabled, you can resend a fax from
Job Status in Job/Status.
User's Guide
Solving Problems
210

Epson WF-C17590 Series Specifications

General

Brand	Epson
Model	WF-C17590 Series
Category	Printer
Language	English