Ericsson T39 - Page 184

AT Commands Modem Terminated 182
AT+FTBC Phase C Transmit Data Block Size
AT+FVRFC Vertical Resolution Format Conversion
1 The TE can receive a polled document. After a polled
document is received, the <value> setting is reset to ‘0’.
Description: Selects stream mode or block mode for Phase C data transfer. Sets the size of the
transmit data block.
Set command: AT+FTBC=<value>
Read command: AT+FTBC? Displays the current <value> setting.
Test command: AT+FTBC=? Shows if the command is supported.
Test command
response:
+FTBC: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0 Stream mode only. Block size set to zero
Default setting
Description: Determines the TAE response to a mismatch between the vertical resolution negotiated
for the facsimile session, indicated by the AT+FDCS <vs> parameter, and the Phase C
data desired by the TE, indicated by the AT+FDT <vr> parameter, or the AT+FDIS
<vr> parameter for the AT+FDR operation.
Set command: AT+FVRFC=<value>
Read command: AT+FVRFC? Displays the current <value> setting.
Test command: AT+FVRFC=? Shows if the command is supported.
Test command
response:
+FVRFC: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0 Disables mismatch checking. The TE must check the
AT+FDCS <vr> parameter, and transfer matching data
Default setting
<value> Description