AT Commands Modem Terminated 183
AT+FWDFC Page Width Format Conversion
5.6.2 Unsolicited result codes
+FET FET Indication
+FHNG FHNG Indication
Description: Determines the TAE response to a mismatch between the page width negotiated for
the facsimile session, indicated by the AT+FDCS <wd> parameter, and the Phase C
data desired by the TE, indicated by the AT+FDT <wd> parameter, or the AT+FDIS
<wd> parameter for AT+FDR operation.
A mismatch would require clipping or scaling a wider format to a narrower one.
Set command: AT+FWDFC=<value>
Read command: AT+FWDFC? Displays the current <value> setting.
Test command: AT+FWDFC=? Shows if the command is supported.
Test command
response:
+FWDFC: (list of supported <value>s)
Parameter:
<value>:
<value> Description
0 Disables mismatch checking. The TE must check the
AT+FDCS <wd> parameter, and transfer matching data
Default setting
Description: Post-page message. The +FET: <ppm> message is generated by a receiving facsimile
TAE after the end of Phase C reception, on receipt of the post-page message from the
transmitting station.
Unsolicited result code:+FET: <ppm>
Parameter:
<ppm>: See the AT+FET command.
Description: Indicates that the call has been terminated. The hang-up cause is reported, and stored
in the AT+FAXERR parameter for later inspection.
Unsolicited result code:+FHNG: <hsc>
Parameter:
<hsc>: Hang-up status code.
<hsc> Description
0-9 Call placement and termination
0 Normal and proper end of connection
1 Ring Detect without successful handshake
2 Call aborted, from AT+FK
To Next Page
Loading...
