100i / 200i / 300i / 400i
14 SAFETY INSTRUCTIONS Manual PN: 0560956430
!
Meaning of symbols - As used throughout this manual: Means Attention! Be Alert! Your safety is involved.
Means immediate hazards which, if not avoided, will result in immediate, serious per-
sonal injury or loss of life.
Means potential hazards which could result in personal injury or loss of life.
Means hazards which could result in minor personal injury.
Enclosure Class
The IP code indicates the enclosure class, i.e. the degree of protection against penetration by solid objects or water.
Protection is provided against touch with a finger, penetration of solid objects greater than 12mm and against
spraying water up to 60 degrees from vertical. Equipment marked IP21S may be stored, but is not intended to be
used outside during precipitation unless sheltered.
This product is solely intended for plasma cutting. Any other use may result in personal
injury and / or equipment damage.
If equipment is placed on a surface that slopes more
than 15°, toppling over may occur. Personal injury and
/ or signicant damage to equipment is possible.
15°
Art# A-12726
Art# A-12736
To avoid personal injury and/or equipment damage,
lift using method and attachment points shown here.
To Next Page
Loading...
