EtherWAN EW50 User Manual

EW50 Industrial LTE Cellular Gateway
138
Enable UDP Mode Window
Item
Value setting
Description
Operation Mode
Required setting
Select UDP mode.
Listen Port
4001 is set by default
Indicate the listening port of UDP connection.
Value Range: 1 ~ 65535
Enable
Unchecked by default
Check the Enable box to activate the corresponding serial port in specified
operation mode.
Save
N/A
Click Save to save the settings
Undo
N/A
Click Undo to cancel the settings
Specify Remote UDP
Specify Remote UDP hosts Window
Item
Value setting
Description
Host
Required setting
Press Edit button to enter IP address range of remote UDP hosts.
Remote Port
4001 is set by default
Indicate the UDP port of peer UDP hosts.
Value Range: 1 ~ 65535
Serial Port
SPort-0 is set by default
Apply the UDP hosts for a selected serial port. Up to 4 UDP servers can be
configured at the same time for each serial port.
Definition
Enable
Unchecked by default
Check the Enable box to enable the rule.
Save
N/A
Click Save to save the settings
Undo
N/A
Click Undo to cancel the settings

EtherWAN EW50 Specifications

General

Brand	EtherWAN
Model	EW50
Category	Gateway
Language	English