EtherWAN EW50 User Manual

EW50 Industrial LTE Cellular Gateway
186
Note: User Name will be available only when TLS is chosen in Authorization
Mode.
Bridge TAP to
By default VLAN 1 is
selected
Specify the setting of “Bridge TAP to” to bridge the TAP interface to a certain
local network interface or VLAN.
Note: Bridge TAP to will be available only when TAP is chosen in Tunnel
Scenario and NAT is unchecked.
Firewall Protection
Unchecked by default
Check the box to activate the Firewall Protection function.
Note: Firewall Protection will be available only when NAT is enabled.
Client IP Address
By default Dynamic IP is
selected
Specify the virtual IP Address for the OpenVPN Client.
Select from Dynamic IP/Static IP.
Tunnel MTU
1. Required setting
2. Default is 1500
Specify the value of Tunnel MTU.
Value Range: 0 ~ 1500.
Tunnel UDP
Fragment
The value is 1500 by
default
Specify the value of Tunnel UDP Fragment.
Value Range: 0 ~ 1500.
Note: Tunnel UDP Fragment will be available only when UDP is chosen in
Protocol.
Tunnel UDP MSS-
Fix
Unchecked by default
Check the Enable box to activate the Tunnel UDP MSS-Fix function.
Note: Tunnel UDP MSS-Fix will be available only when UDP is chosen in
Protocol.
nsCerType
Verification
Unchecked by default
Check the Enable box to activate the nsCerType Verification function.
Note: nsCerType Verification will be available only when TLS is chosen in
Authorization Mode.
TLS Renegotiation
Time (seconds)
The value is 3600 by
default
Specify the time interval of TLS Renegotiation Time.
Value Range: -1 ~ 86400.
Connection
Retry(seconds)
The value is -1 by default
Specify the time interval of Connection Retry.
The default -1 means that there is no need to execute connection retry.
Value Range: -1 ~ 86400, and -1 means no retry is required.
DNS
By default Automatically
is selected
Specify the setting of DNS.
Select from Automatically/Manually.

EtherWAN EW50 Specifications

General

Brand	EtherWAN
Model	EW50
Category	Gateway
Language	English