EtherWAN EW50 - Page 190

EW50 Industrial LTE Cellular Gateway
190
L2TP Server Configuration
Item
Value setting
Description
L2TP Server
Unchecked by default
Click the Enable box to activate L2TP server
L2TP over IPSec
Unchecked by default
Click the Enable box to enable L2TP over IPsec and need to fill in the Pre-shared
Key (8~32 characters).
Server Virtual IP
Required setting
Specify the L2TP server Virtual IP.
IP Pool Starting
Address
1. Required setting
2. 10 is set by default.
Specify the L2TP server starting IP of virtual IP pool.
Value Range: 1 ~ 254.
IP Pool Ending
Address
1. Required setting
2. 17 is set by default.
Specify the L2TP server ending IP of virtual IP pool.
Value Range: >= Starting Address, and < (Starting Address + 8) or 254.
Authentication
Protocol
Required setting
Select single or multiple Authentication Protocols for the L2TP server with
which to authenticate L2TP clients. Available authentication protocols are PAP /
CHAP / MS-CHAP / MS-CHAP v2.
MPPE Encryption
Required setting
Specify whether to support MPPE Protocol. Click the Enable box to enable
MPPE and from dropdown box to select 40 bits / 56 bits / 128 bits.
Note: when MPPE Encryption is enabled, the Authentication Protocol PAP /
CHAP options will not be available.
Service Port
Required setting
Specify the Service Port which L2TP server will use.
Value Range: 1 ~ 65535.
Save
N/A
Click the Save button to save the configuration.
Undo
N/A
Click the Undo button to recover the configuration.
L2TP Server Status
Item
Value setting
Description
L2TP Server Status
N/A
Displays the User Name, Remote IP, Remote Virtual IP, and Remote Call ID of
connected L2TP clients.
Click the Refresh button to renew the L2TP client information.