EW50 Industrial LTE Cellular Gateway
301
Status are Connected or disconnected.
Renew button allows user to force the device to request an IP address from
the DHCP server. Note: Renew button is available when DHCP WAN Type is
used and WAN connection is disconnected.
Release button allows user to force the device to clear its IP address setting to
disconnect from DHCP server. Note: Release button is available when DHCP
WAN Type is used and WAN connection is connected.
Connect button allows user to manually connect the device to the Internet.
Note: Connect button is available when Connection Control in WAN Type
setting is set to Connect Manually (Refer to Edit button in Basic Network >
WAN & Uplink > Internet Setup) and WAN connection status is disconnected.
Disconnect button allows user to manually disconnect the device from the
Internet. Note: Disconnect button is available when Connection Control in
WAN Type setting is set to Connect Manually (Refer to Edit button in Basic
Network > WAN & Uplink > Internet Setup) and WAN connection status is
connected.
WAN interface IPv6 Network Status
WAN interface IPv6 Network Status screen shows status information for IPv6 networks.
WAN interface IPv6 Network Status
Displays corresponding WAN interface WAN IDs.
Displays the type of WAN physical interface.
Depending on the model purchased, it can be Ethernet, 3G/4G, etc.
Displays the method which public IP address is obtained from your ISP. WAN
type setting can be changed from Basic Network > IPv6 > Configuration.
Displays the LAN IPv6 Link-Local address.
Displays the IPv6 global IP address assigned by your ISP for your Internet
connection.
Displays the connection status. The status can be connected, disconnected
and connecting.
This area provides functional buttons.
Edit Button when pressed, the web-based utility will take you to the IPv6