Test Setup - Test Configurator, Timer, and System
MaxTester 95
EtherBERT and Unframed BERT
Disruption Monitoring check box when selected (disabled by
default) enables the disruption time measurements. However, the
measurement will only start if the test is already started, or when the
test will be started.
Note: Clearing the Disruption Monitoring check box will stop the measurement
without clearing the results. The disruption monitoring is automatically
stopped without clearing results when the test is stopped. However, starting
the test again while the Disruption Monitoring check box is selected will
reset the results before restarting.
Pass/Fail Verdict allows enabling and configuring the SDT Threshold.
SDT Threshold allows configuring the amount of time with no traffic
that is accepted before failing the test: 0.005 to 299999.995 ms in step
of 0.005 ms (default is 50 ms) for 10M to 10G; 0.001 to 299999.999 ms in
step of 0.001 ms (default is 50 ms) for 100G. For EtherBERT, the
threshold value cannot be less than the No Traffic Time value.
Shaping
TX Rate allows the selection of the transmission rate in percentage of
utilization (100 percent by default), Mbit/s, Gbit/s, Frame/s, or IFG. For
Ethernet, the maximum percentage is 105 percent depending on the
frame size selected.
Enable TX check box is automatically selected when starting the test
allowing stream generation. The Enable TX check box may also be
selected or cleared while the test is running. Not available for FC BERT.
To Next Page
Loading...
