Test Results
MaxTester 263
MPLS
MPLS
For Traffic Gen and Mon, from the test menu, tap Results, Streams, and
the MPLS tab.
For Though Mode, from the test menu, tap Results, Traffic, and the MPLS
tab.
Note: For Dual Port topology select the port to be displayed.
Label 1 and Label 2
The number of MPLS frames transmitted (TX) and received (RX) are
displayed for both Label 1 and Label 2 for each Stream. Not available for
Through Mode test application.
Total TX/RX MPLS
Line Utilization indicates the percentage of MPLS line rate utilization
in TX and RX.
Ethernet BW (%) (Ethernet Bandwidth) indicates the MPLS data rate
in TX and RX.
Frame Rate (frames/s) indicates the number of transmitted (TX) and
received (RX) MPLS frames.
Frame Count indicates the count of transmitted (TX) and received
(RX) MPLS EtherType (0x8847 or 0x8848) frames regardless if FCS is
good or not.
To Next Page
Loading...
