EXFO MAX-890 - RFC 2544 - Global

Test Setup - Test Configurator, Timer, and System
MaxTester 139
RFC 2544 - Global
RFC 2544 - Global
From the Test menu, tap Setup, Test Configurator, tap on the RFC 2544
block, and on the Global tab.
Dual Test Set
 Dual Test Set (DTS) check box when selected (cleared by default)
enables RFC 2544 Dual Test Set. Once Dual Test Set is enabled, use
the Discover Remote button to select a remote unit. Not available in
Dual Port topology.
Note: It is also possible using the Discover Remote button to connect to a remote
unit and automatically enable Dual Test Set. For more details, refer to
Discover Remote Button on page 380.
 Disconnected indicates that there is no connection established
with a remote unit.
 Connected indicates that the connection is established with a
remote unit.
 Discover Remote button allows discovering remote unit supporting
Remote Loopback and/or Dual Test Set. For more details, refer to
Discover Remote Button on page 380.
Global Options
 Flow Direction allows the selection of the traffic direction as follows:
 TX to RX for Single Port topology.
 Port #1 to Port P2, Port #2 to Port #1, and Bidirectional for
Dual Port topology.
 Local to Remote, Remote to Local, and Bidirectional for Dual
Test Set.