Test Results
MaxTester 279
Streams - Latency
Streams - Latency
From the Test menu, tap Results, Streams, and the Latency tab.
Note: For Dual Port topology select the port to be displayed.
Stream: Indicates the stream identification number.
Latency (ms) is measured for each stream on all valid frames (valid
Latency tag, expected originator identifier value, and no FCS error)
received. Current, Average, Minimum, and Maximum round-trip
latency (delay) are reported.
Note: Latency statistics are only available in loopback test topology.
Note: Delay measurements smaller than 1 μs will be discarded, not used for the
sampling process, and < 0.001 will be displayed. For the Current value,
Not measurable is displayed when no delay has been measured in the last
second.
Thresholds button allows setting the pass/fail thresholds (refer to QoS
Metrics on page 190).
To Next Page
Loading...
