Physical Interfaces and LEDs
MaxTester 17
BNC
BNC
Connector type is BNC for coaxial 75-ohm cable connection. An adapter
cable (BNC to Bantam) is required for Bantam external clock connection
(not supplied).
LEDs
LASER red LED is on when the unit is emitting an optical laser signal.
LINK/RX green LED is on when the link is up, off when the link is down,
and flashing when frames are transmitted and/or received.
DUPLEX green LED is on for Full Duplex mode, off for Half Duplex
mode, and flashing when collisions are detected.
Port blue LED is on when this port is selected for the test, and flashing
when this port is selected for clock input.
To Next Page
Loading...
