EXFO MAX-890 - Modify Structure Button

Test Setup - Test Configurator, Timer, and System
MaxTester 65
Modify Structure Button
Modify Structure Button
From the Test menu, tap Setup, Test Configurator, and the Modify
Structure button.
For Transport Test Applications
TX/RX allows the configuration of the following parameters for either
TX/RX, RX and RX2, TX, or RX depending on the selected topology.
 Interface/Rate: Select the desired interface rate. Choices depend on
the selected test and the rates available on the unit.
Test Interface/Rate
OTN (Parallel) OTU4 (4 Lanes) [111.81 Gbit/s]
OTN (Serial) OTU2 [10.709 Gbit/s]
OTU1 [2.666 Gbit/s]
SONET OC-192 [9.953 Gbit/s]
OC-48 [2.488 Gbit/s]
OC-12 [622.08 Mbit/s]
OC-3 [155.520 Mbit/s]
OC-1 [51.840 Mbit/s]
STS-3e [155.520 Mbit/s]
STS-1e [51.840 Mbit/s]
SDH STM-64 [9.953 Gbit/s]
STM-16 [2.488 Gbit/s]
STM-4 [622.080 Mbit/s]
STM-1 [155.520 Mbit/s]
STM-0 [51.840 Mbit/s]
STM-1e [155.520 Mbit/s]
STM-0e [51.840 Mbit/s]
DSn DS1 [1.544 Mbit/s]
DS3 [44.736 Mbit/s]
PDH E1 [2.048 Mbit/s]
E3 [34.368 Mbit/s]
E4 [139.264 Mbit/s]
NI/CSU Emulation DS1