Test Setup - Test Configurator, Timer, and System
64 MAX-800 Series
Test Configurator Overview
Interface Block displays an overview of the interface settings and
status. Tap on the interface block to change the settings and to see
detailed status. For Dual Port topology, there is an interface block
for each port.
Protocol Block displays an overview of either the frame structure
and its parameters for Ethernet test applications or the embedded
signal for Transport test applications. This block is not present for
all tests. Tap on the protocol block to change the settings and to
see detailed status. For RFC 2544, EtherBERT, and Traffic Gen &
Mon in Dual Port topology, there is a protocol block for each port.
Test Block displays an overview of the test settings and status. Tap
on the test block to change the settings and to see detailed status.
Clock Block displays an overview of the clock settings and status
(only available on MAX-860G using 10G WAN interface and on
MAX-880). Tap on the clock area to change the settings and to see
detailed status. For Dual Port topology, the clock block is not
present but the clock is set to Internal.
To Next Page
Loading...
