Test Results
274 MAX-800 Series
Service Configuration - Ramp
Service Configuration - Ramp
From the Test menu, tap Results, Service Configuration, and the Ramp
tab.
Service Name and Selection
Service Name indicates the name of the selected service. Select the
service to be displayed by either using the left/right arrow or by tapping
over the service numbers area then tapping on a specific service number.
An orange background indicates the selected service while a green
background indicates the services that are enabled.
Committed/Excess Steps
Committed Steps indicate the pre CIR and CIR steps specified in the
ramp configuration.
Excess Steps indicate the CIR+EIR and Traffic Policing steps
specified in the ramp configuration.
Direction, available with Dual Test Set or Dual Port topology,
indicates respectively results for local (L) and remote (R) directions, or
for both port directions.
TX Rate indicates the transmission rate for each step.
SLA Verified indicates the committed SLA parameters that are used to
declare the pass/fail verdict. See Summary (EtherSAM) on page 290 for
more information on Frame Loss Rate, Max Jitter, Round-Trip
Latency, and Max RX Rate.
To Next Page
Loading...
