Test Results
MaxTester 297
Summary (Traffic Gen & Mon)
Summary (Traffic Gen & Mon)
From the Test menu, tap Results, and the Summary tab.
Note: For Dual Port topology select the port to be displayed.
Test Status indicates the actual test status as follows. The global test
pass/fail verdict is displayed next to the Test Status when enabled (see
QoS Metrics on page 190).
“--”: The test is not running or results are not available.
In Progress: The test is running.
Completed: The test is completed, stopped at the planned time, or
manually stopped when there is no set timer.
Start Time indicates the date and time the test was started. The date
and time is reset every time the test is restarted or reset.
Test Recover y when displayed, indicates that the test has
automatically recovered from a power failure. The number of
occurrences is also displayed next to the Test Recover y field. Refer to
Power Failure Recovery on page 403.
Logger Full, when displayed, indicates that the logger is full. Refer to
Logger on page 260.
Stream
The following statistics are available for each stream.
Current Throughput: See Streams - Throughput on page 280.
Frame Loss Rate: See Streams - Frame Loss / Out-of-Sequence on
page 278.
Jitter: See Streams - Jitter on page 278.
Latency: See Streams - Latency on page 279.
To Next Page
Loading...
