Test Results
MaxTester 281
Summary
Summary
Note: Available with Transport, and Ethernet (EtherBERT, Through Mode, and
Smart Loopback) test applications. For other test applications see the
corresponding test summary page.
From the Test menu, tap Results, and the Summary tab.
For Dual Port topology, depending on the application, results may be
displayed either globally or for each port individually. In this case select the
port to be displayed or Global for a brief test summary of both ports.
Test Status displays the current status of the test. The global test
pass/fail verdict is displayed next to the Test Status field when
enabled.
Start Time indicates the date and time the test was started. The date
and time is reset every time the test is restarted or reset.
Test Recover y when displayed, indicates that the test has
automatically recovered from a power failure. The number of
occurrences is also displayed next to the Test Recover y field. Refer to
Power Failure Recovery on page 403.
Logger Full, when displayed, indicates that the logger is full. Refer to
Logger on page 260.
Test Status Description
-- Idle state, the test is not running or results are not available.
In Progress The test is running.
Completed The test is completed, stopped at the planned time, or manually
stopped when there is no set timer.
To Next Page
Loading...
