Test Setup - Test Configurator, Timer, and System
MaxTester 85
Cable Test
Cable Test
From the Test menu, tap Setup, Test Configurator, and the test block.
Global Options
Wiring Standard is the pin-to-pair assignment corresponding to the
UTP cable used: T568A (default) or T568B.
Length Unit is the unit used for cable length and distance to fault
results: Meter (default) or Feet.
Pass/Fail Verdict
Pass/Fail Verdict check box when selected (default) enables the cable
test pass/fail verdict and allows setting the threshold values.
Prop. Delay Threshold (ns) is the maximum time for a pulse to
reach the far end: 0 to 1000 ns (default is 1000 ns for 10 Mbit/s,
556 ns for 100 Mbit/s, and 570 ns for 1 Gbit/s).
To Next Page
Loading...
