Test Setup - Test Configurator, Timer, and System
MaxTester 121
MAC/IP/UDP
MAC/IP/UDP
Note: Only available with Framed Layer 2 (see Framing from the Modify Frame
Structure).
From the Test menu, tap Setup, Test Configurator, and...
For RFC 2544 and EtherBERT, tap on the protocol block.
For EtherSAM, and Traffic Gen & Mon, tap on the protocol block, and
on the MAC/IP/UDP tab.
Stream (Traffic Gen & Mon) / Service (EtherSAM)
Selection
Traffic Gen & Mon supports the configuration of up to 16 different streams.
EtherSAM supports the configuration of up to 10 different services.
Select the stream/service to be configured by either using the left/right
arrow or by tapping over the stream/service numbers area then on a
specific number.
Couple with Interface
The Frame Format, Network Layer, and all IP and VLAN settings are
coupled with the interface (see Network on page 134) when the Couple
with Interface check box is selected (default). The Source MAC Address
is always coupled.
To Next Page
Loading...
