Test Setup - Test Configurator, Timer, and System
106 MAX-800 Series
Frequency
Sweep: increases and decreases repetitively the frequency to
cover the defined frequency offset range using a 1 ppm step at an
average rate of up to 10 ppm/sec. Starting at offset 0 the min value
is reached then repetitively increases to the maximum value then
decreases to minimum value.
Step Size (ppm), available with Fixed frequency, allows setting the
increment/decrement value (from 0.1 to either 50 or 120 depending on
the test configuration) that will be used when changing the frequency
offset with the “+” or “-” button.
Range, available with sweep frequency, allows setting the range for
frequency sweep generation.
To Next Page
Loading...
