Test Setup - Test Configurator, Timer, and System
MaxTester 135
Network
Subnet Mask
1
: Enter the Subnet Mask. The default setting is
255.255.000.000.
Default Gateway
1
check box, when selected (cleared by default),
allows entering a default Gateway IP address. When the Default
Gateway check box is selected, its default address is 0.0.0.0.
For IPv6 the following configuration parameters are displayed: Link-Local
IPv6 Address, Global IPv6 Address, and Default Gateway. Tap on the
Config button to access all settings.
Link-Local IPv6 Address (LLA) is used for local communication
between on-link neighbors and for Neighbor Discovery process.
Mode
Stateless Auto (default) allows automatic generation of the IPv6
address based on the MAC address.
Static allows entering the IP Address.
Address, available with Static mode, allows selecting the
Link-Local IPv6 Address. The accepted range is from
FE80:0000:0000:0000:0000:0000:0000:0000 to
FE80:0000:0000:0000:FFFF:FFFF:FFFF:FFFF. The default address
is FE80::[Interface ID], where [Interface ID] is generated from
the source MAC address. When the Address field is selected for
editing using virtual keyboard, the Previous IPs button appears
allowing the selection of a previously configured IP address.
To Next Page
Loading...
