Test Setup - Test Configurator, Timer, and System
160 MAX-800 Series
Services - Profile
CBS check box when selected (default) sets the maximum committed
burst size to which services’ frames will be sent and be CIR-compliant
(default is 12144 bytes). The CBS minimum and maximum values are
affected by the CIR, Burst Max Rate, and Frame Size values. CBS is
only available when CIR check box is selected.
EBS check box when selected (cleared by default) sets the maximum
excess burst size to which services’ frames will be sent and be
CIR+EIR compliant (default is 12144 bytes). The EBS minimum and
maximum values are affected by the CIR+EIR, Burst Max Rate, and
Frame Size values. EBS is only available when CIR+EIR check box is
selected.
Performance Criteria
Max Jitter (ms) allows setting the maximum jitter value in
millisecond, allowed for the service.
Max Round-Trip Latency (ms) allows setting the maximum round-trip
latency value in millisecond allowed for the service. For Dual Test Set,
only available with Round-Trip Latency Measurement Mode (see
Global Options on page 102). Not available in Dual Port topology.
Max Latency, available for Dual Test Set with One-Way Latency
Measurement Mode (see Global Options on page 102) and Dual Port
topology, allows setting the maximum one-way latency allowed for the
service.
Frame Loss Rate allows setting the maximum rate of Frame Loss
allowed for the service.
Note: For Dual Test Set, the Frame Loss Rate is changed to percentage when the
remote unit does not support exponential notation. In this case a Frame
Loss Rate Threshold lower than 1.0E-06 (0.0001 %) is considered as 0 %.
To Next Page
Loading...
