Test Setup - Test Configurator, Timer, and System
MaxTester 183
Streams - Global
Addressing MAC/IP indicates the source and destination MAC/IP
addresses for each stream. Tap on the Addressing MAC/IP button to
modify the customer addressing (see MAC and IP from the
MAC/IP/UDP tab).
Batch button allows bulk configuration for stream addressing. Select
the check box of each configuration parameter that needs to be copied
and set its parameters. From Apply To, select all streams the copy
applies to and tap on the Copy From to proceed.
The following parameters are global for all streams.
Total TX Rate indicates the percentage of the total line utilization
which is the TX rate sum of all enabled streams.
Link Capacity indicates the total rate available for traffic generation.
Global Options:
Rate Unit choices are % (default), Mbit/s, Gbit/s, frame/s, and IFG.
QoS Metrics Tags Insertion check box when selected (default)
automatically adds a stream analysis tag containing Jitter, Latency,
Throughput, and sequence tags in all frames that is generated.
Copy Stream button allows copying the stream configuration to one or
several streams.
Select the stream number the configuration will be copied from.
From To the following Streams, select all streams that will inherit the
configuration from the selected stream. An orange background
represents a selected stream. A stream that is already enabled (Enable
TX) cannot be selected for copy.
Tap Copy to confirm the stream configuration for all selected streams.
Restore Default button reverts the current test application to its default
factory settings.
To Next Page
Loading...
