Test Results
284 MAX-800 Series
Summary
Disruption Time
Note: For OTL defects, at the exception of LOL, the disruption time is displayed for
the lane having the longest disruption time. See OTL-SDT on page 264 for
results per lanes.
Longest (ms) indicates the longest measured disruption time.
Shortest (ms) indicates the shortest measured disruption time.
Last (ms) indicates the length of the last measured disruption time.
Average (ms) indicates the average duration of all measured
disruption times.
Total (ms) indicates the total duration of all measured disruption
times.
Defect, available with Transport test applications, indicates on which
layer and defect the service disruption time test is performed. For OTL
defect (parallel interface) also indicates within parenthesis the lane
number having the longest disruption time.
Disruption Count: Indicates the number of disruption events detected
since the beginning of the SDT test.
Note: When a disruption event is equal to or longer than the test period which is
fixed to 5 minutes, then the measured disruption time is equal to the test
period.
SDT Threshold (ms) allows entering the SDT threshold value that will
be used to declare the pass/fail verdict: 0.005 to 299999.995 ms in step
of 0.005 ms (default is 50 ms) for 10M to 10G; 0.001 to 299999.999 ms in
step of 0.001 ms (default is 50 ms) for 100G. This setting is only
accessible when Pass/Fail Verdict is enabled and is coupled with the
SDT Threshold set from the test setup (refer to page 83).
To Next Page
Loading...
