Test Functions
MaxTester 339
OH - OTN
SM, columns 8-10, OTU OH: The Section Monitoring contains the
following bytes.
The first SM byte (column 8) contains the TTI multiframe byte that is
only configurable from Traces (OTN) on page 195.
The second SM byte (column 9) contains the BIP-8 byte that is
automatically generated for each frame. This byte is not configurable.
The third SM byte (column 10) contains the following sub-fields. This
byte is configurable from 00 (default) to FF.
GCC0, columns 11-12, OTU OH: The two General Communication
Channel-0 bytes are configurable from 00 (default) to FF. Not
configurable when GCC0 check box is selected from OH BERT on
page 335.
RES, columns 13-14, OTU OH: The two Reserved (RES) bytes are
configurable from 00 (default) to FF.
RES, column 15, OPU OH: The Reserved (RES) byte is configurable
from 00 (default) to FF.
JC, column 16, OPU OH:
Bits 1-6, Reserved (RES), are configurable from binary 000000
(default) to 111111.
Bits 7-8, Justification Control (JC), are configurable from binary
00 (default) to 11. Not available with ODU mux. Changing the JC value
will corrupt the payload.
Bit 1-4 Bit 5 Bit 6 Bit 7-8
BEI/BIAE BDI IAE RES
To Next Page
Loading...
