Selecting and Starting a Test
56 MAX-800 Series
Transport Test Applications
3e. Tap the test block to configure the specific test settings (refer to
page 59). Not available with NI/CSU Emulation test application.
3f. Tap the clock block to configure the clock synchronization (refer
to Clock on page 88).
4. Tap the Timer tab to automatically start and/or stop the test at a given
time or for a specific duration (refer to Timer on page 193).
5. For additional test configurations refer to Test Functions on page 309.
6. Tap the Start button from the right navigation bar to start the test. (refer
to Start/Stop|TX Button on page 402). The Summary result page will
be automatically displayed when the test is started from any Setup
configuration page. For additional results, refer to Test Results on
page 201.
7. Tap the Stop button to stop the test. By default the generate report
pop-up is displayed. If required, tap Yes to generate a report of the test
results and statistics (refer to Report Button on page 392).
To Next Page
Loading...
