Why is the operating time of my EXFO MaxTester Test Equipment reduced?
If your EXFO Test Equipment unit’s operating time is reduced, charge the battery. If the battery was fully charged, the battery is probably worn out.
What to do if an application is not responding on EXFO MaxTester Test Equipment?
To resolve an unresponsive application on your EXFO Test Equipment, press and hold the On/Off button a few seconds until the unit beeps once. Turn the unit on again to reset it.
Why is EXFO MaxTester screen no longer calibrated properly?
If the screen is no longer calibrated properly on your EXFO Test Equipment, even after a recent calibration, it may be because the unit is no longer powered by the same power source (battery or AC) that was in use at the time of screen calibration. Changes in the power source require a new calibration.
General| Display | 7-inch touchscreen |
|---|---|
| Connectivity | USB, Ethernet, Wi-Fi |
| Operating Temperature | -10 °C to 50 °C (14 °F to 122 °F) |
| Category | OTDR |
| Wavelengths | 1310 nm, 1550 nm |
| Event Dead Zone | 0.8 m |
| iOLM | Yes |
| Application | Fiber optic network testing and troubleshooting |
| Humidity | 5% to 95% non-condensing |
Overview of the unit's primary hardware and software capabilities.
Key technical data and performance parameters of the unit.
Critical safety guidelines related to laser radiation.
Safety precautions for handling electrical components and power.
Procedures for powering the unit on, off, and into suspend mode.
Steps to set up regional, language, and other initial settings.
How to move between and launch applications on the unit.
Setting up network and internet connection parameters.
Process for correcting touchscreen input inaccuracies.
Setting up wired and wireless network configurations.
Steps to establish a Wi-Fi connection for network access.
Setting up the VNC server for remote unit control.
Establishing a remote connection to the unit using TightVNC.
Steps and considerations for charging the unit's battery.
Guidance on when and how to perform unit recalibration.
A table listing common issues and their solutions.
Steps to reset the unit to its factory default state.
Contact details and procedures for obtaining technical assistance.
Details on how to obtain service and repair for the unit.
To Next Page
