IN1806 and IN1808 Series Scaling Presentation Switchers • Operation 50
To insert IR signals via the Over TP captive screw connector:
1. Connect the COM (serial) port of the control system to the Over TP IR captive screw
port (output port 1B in this example).
2. Connect the TP cable from the IN1806 and IN1808 Series RJ-45 Out connector to the
DTP input of the endpoint.
3. Connect the endpoint to the device to be controlled.
4. Wire an IR emitter to the IR connector of the twisted pair receiver, and place the emitter
on the display device.
To Next Page
Loading...
