IN1806 and IN1808 Series Scaling Presentation Switchers • SIS Configuration and Control 51
SIS Configuration
and Control
The IN1806 and IN1808 Series scalers can be configured and controlled via Extron Simple
Instruction Set (SIS) commands when connected to a host computer or other device
(such as a control system). Attach the host device to the rear panel RS-232 connector
or LAN connector, or to the front panel USB port. Commands can be entered using a
Telnet application such as the Extron DataViewer, available at www.extron.com (see the
DataViewer Help file for more details). The default protocol for the RS-232 connection is
9600 baud, 8 data bits, 1 stop bit, no parity, and no flow control. This section describes SIS
communication and control. Topics in this section include:
• Host and Scaler Communication
• SIS Overview
• Command and Response Tables for SIS Commands
Host and Scaler Communication
SIS commands consist of one or more characters per field. No special characters are
required to begin or end a command sequence. When the scaler determines that a
command is valid, it executes the command and sends a response to the host device. All
responses from the scaler to the host end with a carriage return and a line feed
(CR/LF =
]
), indicating the end of the response character string (one or more characters).
Copyright Messages
The copyright message is displayed upon connecting to a scaler via TCP/IP or Telnet or
after a power cycle via RS-232, and depends on the scaler model.
]
(c) Copyright YYYY, Extron Electronics, IN180n <model>, Vn.nn,
60-16nn-0n
]
Ddd, DD MMM YYYY HH:MM:SS
]
(day, date, and time as in Mon, 18 Oct 2018 11:27:33)
• YYYY is the year.
• <model>, if applicable, is IPCP SA or IPCP MA 70
• 60-16nn-0n is the model part number:
• IN1806 — 60-1663-01
• IN1808 base model — 60-1615-01
• IN1808 IPCP SA — 60-1615-02
• IN1808 IPCP MA 70 — 60-1615-03
• Vn.nn is the firmware version number.
To Next Page
Loading...
