IN1806 and IN1808 Series Scaling Presentation Switchers • SIS Configuration and Control 53
Error Responses
When the scaler receives a valid command, it executes the command and sends a
response to the host device. If the unit is unable to execute the command, it returns an error
response to the host.
E01 — Invalid input number E17 — Invalid command for signal type
E10 — Invalid command E22 — Busy
E11 — Invalid preset number E24 — Privilege violation
E12 — Invalid port number E25 — Device not present
E13 — Invalid value E28 — Bad filename or File not found
E14 — Not valid for this configuration E33 — Bad file type for logo
SIS Overview
Using the Command and Response Tables
The Command and Response Tables for SIS commands, beginning on page 62, lists
the commands that the scaler recognizes as valid, the responses that are returned to the
host, a description of the command function or the results of executing the command, and
examples of commands in ASCII (Telnet).
ASCII to Hex Conversion Table
•
Figure 32. ASCII to Hexadecimal Character Conversion Table
32
To Next Page
Loading...
